Gas Fireplace Repair in Severance, Colorado

Gas fireplace repair in Severance runs on the same published pricing as Fort Collins (service call $150 to $300, annual service $175 to $350, common part repairs $200 to $600, gas valve $500 to $1,000) about 17 road miles east, roughly 25 minutes through Windsor. Send the model number from the rating plate inside the bottom louver and the symptom, so the technician can bring the right module or pilot assembly in one trip.

What Severance is, fireplace-wise

Severance was incorporated on November 20, 1920 and spent most of a century as a small farm town northwest of Greeley, bordering Windsor to the southwest and Eaton to the northeast. Then it grew faster than almost anywhere in Colorado: the 2020 census counted 7,683 people, an increase of 142.75 percent over 2010, and estimates reached 11,554 by 2023. It sits at 4,876 feet on the plains, low by northern Colorado standards but still well inside the altitude band that matters for gas appliances.

That history produces an unusual fireplace population. There is very little of the 1970s and 1980s stock that fills Loveland and Old Town Fort Collins. Instead:

• A small original core. A handful of older houses with masonry fireplaces, some converted to vented gas log sets on a manual valve and a standing pilot. Thermocouples, pilot hoods, and burner pans.
• The 2010s and 2020s subdivisions, which is nearly everything. Factory direct-vent fireplaces with electronic intermittent pilot ignition, a handheld remote, a receiver, and a four-AA battery backup pack. No standing pilot anywhere in the house.

That second category is the whole job here, and it changes what a good technician brings. Nobody in Severance needs a tech carrying a box of thermocouples. What these units need is ignition modules, pilot assemblies with the spark electrode and flame sensing rod, receivers, and batteries.

What fails in Severance, and what it costs

Clicking with no flame. The signature failure of an electronic unit, and the first three suspects are all free to check: the backup battery pack, the handset, and the receiver. After that it is a pilot orifice with a summer of spider webbing in it, a fouled electrode, or the module. Pilot assembly $300 to $600, module $350 to $700. The clicks but will not light page walks the whole sequence.

Lights, then drops out. The flame sensing rod losing the pilot, usually because it is fouled or cracked. $300 to $600 with the pilot assembly, and the shuts off early page explains how it is measured rather than guessed.

Dead remote. Receiver or wall switch, $150 to $400. Batteries first, and you will hear that for free.

First-winter haze. New houses deposit the heaviest film of a fireplace’s life in their first season, as paint, sealants, and the log set finish curing. That is normal, it cleans off cold ceramic glass with the right cleaner, and it is covered on the white film page.

Altitude at 4,876 feet. The National Fuel Gas Code (NFPA 54 / ANSI Z223.1) calls for derating gas appliances installed above 2,000 feet by about 4 percent per 1,000 feet, and manufacturers’ natural-gas high-altitude kits typically start above 4,500 feet, so Severance is inside the band even though it is one of the lowest towns on this site. On a fast-built subdivision, an altitude kit left in the box is a real thing that happens, and the symptom is glass that soots again a week after it was cleaned.

Permits, licensing, and gas

Severance runs its own Building and Permits function inside town limits, and that is where a permit for a new insert or log set or new gas piping comes from. The town is in Weld County, which adopted the 2024 International Building, Residential, Mechanical, Plumbing and Energy Conservation Codes effective June 15, 2026. Colorado licenses the plumbers who run gas piping at the state level. A like-for-like part repair on an existing fireplace does not need a permit; a new appliance or new piping does, and it gets pulled.

On gas territory, Weld County is split: Greeley to the east is Atmos Energy, while Larimer County’s provider list names Xcel Energy. Which company bills your Severance address prints on the statement, and it is worth knowing before you need the emergency number rather than after.

Gas smell in Severance

Leave the house, leave the door open behind you, do not touch a light switch or a garage door opener, and call your gas utility’s emergency line or 911 from outside. Do not call a contractor first. Once the house has been cleared, the safety inspection and leak check at $125 to $250 finds the fitting.

Getting a quote from Severance

Send the rating plate photo, say that the unit sparks on demand rather than burning a standing pilot, and describe the symptom in a sentence. Severance groups with Windsor and Timnath on the eastern run. Numbers are on the pricing page; process questions are on the FAQ.